Zyngen

The Zyngen is an IV tier multiblock for smelting alloys. The Zyngen is a direct upgrade from the singleblock alloy smelter and Steam Fuser because it gains a 5% speed boost per heating coil tier, a perfect overclock for every 900K in heat capacity, and ${\displaystyle {\displaystyle {\text{Voltage Tier}}\times {\text{Coil Tier}}}}$ parallels. There is no minimum heat for alloy smelter recipes so the perfect overclocks start from 0K. The Zyngen is primarily used for mica insulator foil, reinforced glass, sunnarium alloys, and converting between nuggets and ingots.

The Zyngen has one tiered component. The heating coils determine the heat capacity of the machine and must all be the same tier for the structure to form. The integral encasements are NOT tiered and must be the ones listed below. Buses/hatches may replace any casing anywhere on the structure. Multi-amp and laser energy hatches are not supported, but there can be multiple regular energy hatches for overclocking. Use the Multiblock Structure Hologram Projector to visualize/build the structure with subchannel "coil" to specify the tier of the heating coils.

Structure

• Controller: Front bottom center
• 16 Heating Coil (Tiered)
• 5-12 Inconel Reinforced Casing
• 8 Integral Encasement V
• 1+ Energy Hatch: Any casing
• 1 Maintenance Hatch: Any casing
• 1 Muffler Hatch: Any casing
• 1+ Input Bus: Any casing
• 1+ Output Bus: Any casing

Wallsharing

Zyngens may wallshare each of their sides to save on casings, heating coils, integral encasements, and buses/hatches. No recipe uses more than 1A of power so it is possible to share one energy hatch between two machines.

The Zyngen gains a 5% speed boost per heating coil tier, a perfect overclock for every 900K in heat capacity, and ${\displaystyle {\displaystyle {\text{Voltage Tier}}\times {\text{Coil Tier}}}}$ parallels, as seen in the following table. There is no minimum heat for alloy smelter recipes so the perfect overclocks (POCs) start from 0K. The parallels assume the voltage aligns perfectly with the coil of the same tier, but that does not have to be true.

Input separation is permanently enabled on the Zyngen which prevents SOLID ingredients in different input buses from being used in the same recipe, including any molds. That means a single Zygen with many input buses can support many different molds simultaneously. Just don't forget to stay above the minimum number of inconel reinforced casings.

There are not very many alloy smelter recipes beyond IV. The few that do exist can be split between three crafting input buses. One with no molds, one with an ingot + anvil mold, and one with a nugget + ball mold.