Magnetic Flux Exhibitor

The Magnetic Flux Exhibitor (MFE) is an IV tier multiblock for polarizing metals and separating metallic dusts. The MFE is a direct upgrade from the singleblock electromagnetic polarizer and electromagnetic separator because it can process both types of recipes, runs up to 250% speed, uses as little as 50% of the EU/t normally required, and offers up to 256 parallels. The exact bonuses depend on the tier of the electromagnet in the electromagnet hatch. Only one electromagnet is required and all five tiers have unlimited durability and charge--they are a one time cost to upgrade the machine. The tengam electromagnet is the most powerful and unlocks the ability to use one multi-amp energy hatch instead of regular energy hatches.

The MFE has no tiered components. The glass can be any tier and has no effect on the operation on the machine. Buses/hatches may replace any casing anywhere on the structure. Laser energy hatches are not supported, but there can be multiple regular energy hatches for overclocking. One multi-amp energy hatch is allowed if using a tengam electromagnet. Use the Multiblock Structure Hologram Projector to visualize/build the structure with subchannel "glass" to specify the tier of the glass.

Unique to the MFE is the electromagnet hatch which holds ONE electromagnet for the machine. There is only one valid location for the hatch and that is the casing just above and behind the controller.

Structure

• Controller: Front bottom center
• 64-73 MagTech Casing
• 37 Magnetic Neodymium Frame Box
• 12 Any Tiered Glass
• 1 Electromagnet Hatch: One block above/behind controller
• 1+ Energy Hatch: Any casing
• 1 Maintenance Hatch: Any casing
• 1+ Input Bus: Any casing
• 1+ Output Bus: Any casing

Wallsharing

MFEs may wallshare each of their sides to save on casings, frame boxes, and buses/hatches. That does not include the electromagnet hatch due to the restriction on its location. No recipe uses more than 1A of power so it is possible to share one regular energy hatch between two machines.

The MFE is a direct upgrade from the singleblock electromagnetic polarizer and electromagnetic separator because it can process both types of recipes, runs up to 250% speed, uses as little as 50% of the EU/t normally required, and offers up to 256 parallels, as seen in the following table.

An electromagnet is required in the electromagnet hatch to run any recipes in the MFE. All five tiers have unlimited durability and unlimited charge--they are a one time cost to upgrade the machine. They do not stack because there cannot be more than one. The tengam electromagnet is the most powerful and unlocks the ability to use one multi-amp energy hatch instead of regular energy hatches.

• 
  Iron
• 
  Steel
• 
  Neodymium
• 
  Samarium
• 
  Tengam

The MFE has two operating modes, listed below. Switch modes in the GUI of the controller or by right-clicking the controller with a screwdriver. The separator mode is not very useful for ore processing, but it can help with extracting neodymium and chrome dust from sluice sand dust. Later on, it is used extensively for extracting purified tengam dust from raw tengam dust.

• Separator - Runs ONLY electromagnetic separator recipes.
• Polarizer - Runs ONLY electromagnetic polarizer recipes.