Industrial 3D Copying Machine

The Industrial 3D Copying Machine is an EV tier multiblock for chiseling blocks into any of their decorative variants. The Industrial 3D Copying Machine is a direct upgrade from the singleblock auto-chisel because it runs at 300% speed, only uses 75% of the EU/t normally required, and offers 16 parallels per voltage tier. The target block is specified with a ghost item (chisel bus), a pattern output (crafting input bus/buffer), or a programmed circuit (regular input bus).

The Industrial 3D Copying Machine has no tiered components. The glass can be any tier and has no effect on the operation of the machine. The heating coil must be cupronickel specifically and also has no effect on the operation of the machine. Buses/hatches may replace any sturdy printer casing anywhere on the structure. Multi-amp and laser energy hatches are not supported, but there can be multiple regular energy hatches for overclocking. Use the Multiblock Structure Hologram Projector to visualize/build the structure with subchannel "glass" to specify the tier of the glass.

Unique to the Industrial 3D Copying Machine is the chisel bus which is effectively a large input bus with 32/48/64 item slots and 1/4/9 template slots depending on the tier of the bus. The template slots are for specifiying the target block(s) with ghost items, which can be dragged in from NEI.

Structure

• Controller: Front left, 3rd layer
• 40-48 Sturdy Printer Casing
• 37 Steel Frame Box
• 18 Any Tiered Glass
• 12 Steel Pipe Casing
• 6 Steel Gear Box Casing
• 1 Iron Fence
• 1 Cupronickel Coil Block
• 1+ Energy Hatch: Any printer casing
• 1 Maintenance Hatch: Any printer casing
• 1 Muffler Hatch: Any printer casing
• 1+ Input/Chisel Bus: Any printer casing
• 1+ Output Bus: Any printer casing

Wallsharing

Industrial 3D Copying Machines may wallshare each of their sides to save on casings, frame boxes, glass, and buses/hatches. No recipe uses more than 1A of power so it is possible to share one energy hatch between two machines.

The Industrial 3D Copying Machine is a direct upgrade from the singleblock auto-chisel because it runs at 300% speed, only uses 75% of the EU/t normally required, and offers 16 parallels per voltage tier, as seen in the following table.

Every chisel recipe has a base duration of 1.0s and consumes 16 EU/t (LV) prior to any overclocking or speed bonuses. The target block is specified with a ghost item (chisel bus), a pattern output (crafting input bus/buffer), or a programmed circuit (regular input bus). If no target block is specified then the machine defaults to the next available chisel recipe.